Yes! That’s it - Matfer. I think America’s Test Kitchen recommend them and I’d follow ATK off a cliff on kitchen advice. So far, the pans have been fantastic, but I can’t imagine there’s a whole lot to go wrong with a carbon steel pan.
Yes! That’s it - Matfer. I think America’s Test Kitchen recommend them and I’d follow ATK off a cliff on kitchen advice. So far, the pans have been fantastic, but I can’t imagine there’s a whole lot to go wrong with a carbon steel pan.
Bonus points if you budget a little extra and make friends with a local upholster. They can work magic in turning that solid, but ugly, chair from something your grandma would have to something you might find in a design magazine.
Carbon steel pans. You season and treat them like cast iron, but they develop a beautiful, smooth, non stick surface. I just made two over easy eggs in mine. They’re basically all I use anymore - no PFOx, no muss.
I thought I bought two from a French company that started with an ‘M’ but I can’t figure out which brand 😂
Park them outside where they’ll be stolen by Kia Boiiyz*
(post comment edit - if you put things inside < > as your entire post, Lemmy will eat it. Cool>
Yep - I bought sync way back in the day and paid less than $5 for it. Used it for years and years across multiple devices until I switched to iOS. I got my moneys worth for sure - $20 seems like a bargain.
No doubt, it’s a chicken or egg problem.
It’s French, I suspect based on the entity receiving the payment
I haven’t done any Signal app recruiting in my circle of contacts (in fact, I don’t think I’ve talked to anyone about it) and I have 14 contacts that have it installed at the very least. I don’t think it would be a huge push to make Signal more prevalent.
The uphill battle is making a dent in iMessage adoption, which seems to be deeper and deeper entrenched every day.
MUSHROOM MUSHROOM
I got a “new homeowners” tool kit from Ryobi, so I have my light duty tools there (oscillating saw, drill, impact driver, sawzall.)
My heavy duty stuff is Makita - impact wrench, hammer drill, etc.
What temp?
Hoffman seems to be pretty approving and I’d follow that guy off a cliff.
I’ve arrived at the same conclusion re: fractions of a penny front-running.
I have the same dell form factor - 3060. Love it.
You should spend some time reading the literature of tankless heaters - the child post below explains it. Tankess heaters can only raise temp at certain flows. So, if your incoming water is ~55 degrees, it might be able to heat to 110 degrees and flow 6.6 GPH - basically one shower. In that scenario if someone turned on the hot water for… say… dishes, the tankless can’t keep up with demand and the overall output will be colder. Probably not cold but it might not be what you wanted.
The more expensive you go, the more the tankeless can do concurrently, but the more sacrifices you’ll make: they’ll be physically larger, they might require a bigger gas line, etc.
In that case, I would assume they’re talking about how cold the incoming water would be.
I used a tankless in a zone five area where our incoming water in the winter was often below 60 degrees. You’ll have to compare the charts of input temp and output GPH to determine how it would work for your specific use case.
I used an indoor mounted one, but there are tankless models intended for places like CA and AZ where they can be mounted outside.
We liked the endless hot water - we only had one bath and three people, so we offer were bumping against the 60 gallons of our old tank model.
deleted by creator
deleted by creator
Sure are! They’re all steel.